Hook up led strip lights

Published: 31.05.2018

Remove casing - Pull on the outer casing of the cable and slide it off the wires inside. Place Medium Tubing - Just like with the other pieces, slide the medium tubing over the wires and down the cable until it is out of the way.

How to determine a sufficient power supply Skill Level: Check out the information here! Route the 4 wires up to the engine bay and connect them to the module box.

Sign up to get your own personalized Reddit experience!

Make sure that the solder job is as clean as possible to prevent any extra resistance in the wire. Enjoy the new light! You will want to give yourself enough length of wire that it is easy to work with, but not too much as you'll need to be able to cover it back up.

Visit this tutorial to learn proper spacing techniques to be sure that your light box and channel letters glow as one even light. Use of this site constitutes acceptance of our User Agreement and Privacy Policy.

Prepping the power cable - In order to use this power cable we need access to the wires.

How to Cut and Connect LED Light Strips.

Those three wires are the standard AC power connections you find in most homes at least in the U. Read our guidelines before posting New to reddit? Click here to learn more about these quick and easy connectors, although we always recommend soldering for the best possible connection.

If you leave your info and details about your request, we will get the right person to call you back as soon as we can.

    1. Silvestor_Manchini - 06.06.2018 in 23:05

      As before, make sure none of the wires are exposed and use the lighter to shrink the tubing.

      Max_Runy - 16.06.2018 in 17:53

      As you do this, be careful not to pull too hard as you could put a short in the cable.

      Jon_Hantan - 18.06.2018 in 21:38

      Use the wire clothes hanger take it apart and wrap the LED strip electric wires around it so it can push the wire up thought the hole and reach it near the battery.

      Logan_Neal - 19.06.2018 in 23:32

      View this tutorial to see how to properly install an RGB Controller and incorporate a Signal Amplifier when necessary.

      Alberto_Romiros - 26.06.2018 in 22:36

      Leura Fine - Interior Designer. You just need to get something like this that is meant to be hardwired in.

    Add review

    Your e-mail will not be published. Required fields are marked *

    Privacy Policy - Terms of Use Contact Us
    Copyright © 2008-2018 lonelypeopleart.com All rights reserved.