Chainsaw fuel line hook up

Published: 30.04.2018

It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult. The bottom nipple is the main fuel line skinny line with fuel filter attached.

About the Author Amie Taylor has been a writer since I have attached a diagram for how the fuel lines are to be routed. I found a video that shows how the lines should be connected.

Chainsaws, mowers,blowers and trimmers. It's so they stay EPA compliant for emissions standards. Ask an Expert Experts are full of valuable knowledge and are ready to help with any question. All Departments All Departments.

Thanks for your patience. The gasket behind the carb is there,right? Click on the following link to watch the video. Left side is where the red lever is. Thank you so very much!!!!!!!!

Install Chainsaw Fuel Line In 20 Seconds: Make The Homemade Tool

Hold the lengths of the original tubing against the replacement tubing and cut the new tubes to the same lengths to ensure a proper fit. Didn't find what you are looking for? Looking for a carb for kohler generator. Wayne Engine Rebuilder 1, satisfied customers. Alternatively, a pair of hemostats are another tool that allow you to perform the same function. Slice the diagonal end off with the knife.

    1. Maxim_Tyan - 07.05.2018 in 07:36

      How to Replace a Chainsaw Fuel Line.

      Roman_Williams - 08.05.2018 in 21:35

      Once you have even a small piece of tubing that emerges into the hole in the tank, use a pair of bent needle-nose pliers to grasp the tubing and pull it through. Step 4 Pinch the fuel line with the needle-nosed pliers and unhook it from its elbow connector.

      Richard_Minnesota - 14.05.2018 in 08:47

      Left side is where the red lever is. Measure the distance needed to get the fuel lines to the carburetor and then cut the lines straight.

      Moshennik_Solko - 19.05.2018 in 22:31

      Login Contact Us Search.

      Snake_Old - 26.05.2018 in 17:03

      Step 1 Get rid of any gas still left in the tank by pouring it out into an approved fuel container. This line needs inches of slack inside the tank so the fuel pick up will always stay in the gasoline.

    Add review

    Your e-mail will not be published. Required fields are marked *

    Privacy Policy - Terms of Use Contact Us
    Copyright © 2003-2018 All rights reserved.