Hook up led light my car

Published: 13.06.2018

After I open the fuse box, I have no idea what to do, what connects to where and where I am supposed to attach the red and black wires. Components for this project: I would use the radio fuse for this.

We have a be nice policy. Secure the LED strip with zip ties.

Then a ground wire is tapped-in into that same extra wire length on the - side and gets grounded to a bolt. No problem, we are here to help. Hi, I bought these LED strips to put under my dash. These are 20 amp switches.

** March Madness Is On! **

When you create a circuit a loop of electricity from the battery to your LED Light bar , if you just put a switch between the battery and the light, it will have to be rated for the full current amp draw of the light. When it is off, and you put your high beams on, your LED light will still be off and vice versa. Place the module box close to the battery, but away from the engine or radiator so there is no risk of heat damage.

I can't imagine having to have 3 on off switches Make sure to leave enough slack on the other end in order to have enough room to work with.

L.E.D Interior Foot Well Light Install - Genesis Coupe

Connect the fuse holder to the positive side of the battery by unscrewing the nut on the battery. Now is a good time to see if the underside of your car has any way of securely attaching the LED strips, including bolts, brackets or other small openings. Route the 4 wires up to the engine bay and connect them to the module box. Before you proceed with the installation, clean the areas that you will be attaching the LED strips on. Mitsubishi Galant - Car Customization.

    1. Mike_Torreno - 21.06.2018 in 22:05

      It helps if you have a friend to help you hold the LED strip in place during the attachment process, but if not you can just use the double-sided tape to temporarily mount the LED strip in place before you permanently secure it with zip ties. Used Cars For Sale.

      Andy_Hunt - 22.06.2018 in 16:30

      Please be positive and constructive.

      Marshal_Matters - 01.07.2018 in 09:26

      I would use the radio fuse for this. The red wires need to be connected to the fuse box.

      Gringo_Raut - 08.07.2018 in 17:46

      Thanks for sharing this. We recommend zip-ties for every 12 inches of the LED strip, since double-sided tape may not be strong enough to securely attach the strip indefinitely.

    Add review

    Your e-mail will not be published. Required fields are marked *

    Privacy Policy - Terms of Use Contact Us
    Copyright © 2002-2018 lonelypeopleart.com All rights reserved.